![]() ![]() Any probes detected by the Neuropixels PXI plugin will be calibrated automatically when the plugin is loaded, provided that calibration files are stored in one of the following locations:Ĭ:\ProgramData\Open Ephys\CalibrationInfo\ (recommended) ![]() Neuropixels probes require ADC and gain calibration in order to function properly. After the probes turn green, the plugin is ready to begin data acquisition. Once they are initialized, connected probes become green. When the probes are initially detected, they show up as orange circles. Each basestation can communicate with up to 4 probes (for Neuropixels 1.0, NHP, and Ultra) or 8 probes (for 2.0). The editor will automatically create a probe selection interface for each basestation that’s available. If no PXI basestations are found, the plugin can be run in simulation mode. The GUI will automatically connect to any available basestations in your connected PXI chassis. Once your PXI system is up and running, you can drag and drop the “Neuropix-PXI” module from the Processor List onto the Editor Viewport. See section 4.2.2 of the User Manual for installation instructions. Prior to using your Neuropixels PXI basestation, you must install the Enclustra drivers (available for Windows 7/8 and Windows 10). Before using this plugin, make sure you’ve followed all of the steps in the Neuropixels User Manual to set up and configure your hardware.
0 Comments
Leave a Reply. |