![]() Enter the Wireless LAN Mac Address from the WRT54G then click Save Settings. NOTE: In this example, WEP security was used.Ĭlick on the AP Mode sub-tab then select the Wireless Repeater option. If wireless encryption was enabled on your router, select Enable for the Wireless Security option then click on the Edit Security Settings button.Įnter the same wireless security settings that the router is using then click Save Settings. NOTE: To know how to check the wireless settings of your router, click here. On the web-based setup page, just leave the Configuration Type to Static IP Address and enter the same wireless settings that the WRT54G is using, like SSID and Channel then click Save Settings. NOTE: The default username is blank and password is admin. Enter the User name and password of the WAP54G then click OK. NOTE: The default IP address is 192.168.1.245.Ī new window will prompt for a User name and Password. On the Address bar, enter the IP address of the WAP54G then press. ![]() Open a web browser like Internet Explorer. NOTE: This article assumes that you already have the WRT54G configured and you know your wireless settings.Ĭonnect the WAP54G directly into one of the WRT54G’s numbered ports. WAP54G - Firmware must be 2.06 or higherįor instructions on how to upgrade the firmware, click here.WRT54G - Firmware must be 2.02.2 or higher.Before starting the setup, make sure your devices meet the following requirements: This article will guide you on how to set up a WAP54G as a wireless repeater with a WRT54G router.
0 Comments
Leave a Reply. |